Aluminium Cable Lug (Uncoated), DIN Standard

DIN 48201, DIN 57295

Share on facebook
Share on twitter
Share on linkedin
Share on print
Share on whatsapp


For aluminium conductors.


Al99.5 F10



Sector-shaped conductors must be rounded with round-forming dies before compression.
Cable lugs are pre-filled with compression compound and sealed in plastic.

Cat. No.Ref.Conductor
sq. mm
ֳ˜ mm
Die Code
100 Pcs.
101300160 16x816 5.1 12 5.6 8.5 52 18 1.6
10130016225x8256.312 6.8 8.5 60 191.6
101300164 35x10 35 7.5 14 810.5 72 24 2.5
101300166 50x10 50 9.0 16 10.0 10.575 23 3.2
10130016970x12 7010.5 18 11.5 13.0 8828 4.6
101300171 95x12 95 12.5 22 13.5 13.0 92 347.9
101300173120x12 12014.0 22 14.8 13100338.4
101300175150x12 15015.7 25 6.513.0 97379.8
101300180185x16 18517.528 18.3 171114114.1
101300183240x16 24020.3 32 21.51712847 20.2

User Instructions:

The compression cable lugs are marked with a code number in front of the logo (roughly corresponding to the outer diameter of the compression sleeve). The required compression die is selected in accordance with this code number.

For hexagonal compressions made with hand-operated mechanical compression tools, browned dies (black) are to be used for copper cable lugs, whereas aluminium cable lugs require electro-galvanized dies (white).

For hydraulic compression tools there is no differentiation of dies for copper or aluminium cable lugs.

The compression sleeve of aluminium cable lugs is pre-filled with compression compound which must not be removed before the compression, neither completely nor in part. Any compression compound escaping during the compression should be wiped off.

Copper cable lugs are not pre-filled with compression compound.

Assembly Instructions

  1. Clean the conductor or cable ends with a wire brush to remove dirt and oxidation.
  2. Insert conductor or cable ends into the compression sleeve up to the stop.
  3. Before proceeding, make sure that the code number on the cable lug matches that on the compression die.
  4. Cable lugs are compressed by starting from the plate end and working out toward the sleeve end. The number of compressions is marked on the sleeve. It is important to make the specified number of compressions.





Share on facebook
Share on twitter
Share on linkedin
Share on print
Share on whatsapp

Related products

Close Menu


Skip to content